Old Speed Power

This was the base for building a Old Speed powerplant, a very good used (only 30 hours) pumpengine.
The plan is to pep up the little 30-horse powerplant a little.

Picture shows the parts that will be used to bolt the engine back together.

This is the list of things that are done:

- the heads have lost some volume in the combustionchamber (to achive the desired compressionratio of 8/1)

- original intakevalves will be replaced with 33mm valves

- 3-angle valve job will be performed to increase the flow

- NOS Okrasa cam will be dropped in the case

- NOS FRAM-filter will take care of the oilfiltering

- breathing will be handled by a Riechert kit

- exhaust gasses are going to escape thru a merged header.

Stayed tuned to see a picture of the finished engine...